|
Post by Meph on Sept 14, 2016 13:01:36 GMT
Not the end of the world but I had a bad print recently that went unchecked overnight and I think I might have damaged the print end. Printrbot says they are "consumable" and WILL need to be replaced over time anyways. So last night I was having issues over and over with prints messing up and this morning I began one while the kids were waiting on the bus. The PLA managed to get all gummed up and actually tear the kevlar heat sock. $28 later and I have a new heat sock and print end on the way. Not a big deal but it just shows the damage a couple un-attended bad prints can do.
|
|
|
Post by l7arkness on Sept 14, 2016 18:09:34 GMT
RIP its a issue but at least it didn't damage the bed
|
|
|
Post by Deleted on Sept 14, 2016 23:47:56 GMT
That sucks, but at least it's easily fixed.
|
|
valas
Room Planner
I'm being twisted, on the sideway down.
Posts: 459
|
Post by valas on Sept 19, 2016 2:31:49 GMT
It sucks! But soon you will be printing again.
|
|