|
Post by jennifer on Mar 19, 2016 19:36:07 GMT
I'd like to print tiles at .2 layer height and then when almost done switch to .1 layer height for nice detail on the top of the tile. I asked this question in Wanhao Duplicator I3 group on Thingiverse. Got a good reply and found out about a Cura Plugin: Swap At Z www.youmagine.com/designs/swap-at-zI need to try this. Once the gcode file is generated for a particular file, you won't have to do it again which is nice. Just keep reprinting that gcode. I might even go with a .3 layer height the first 90 percent of the tile then switch to .1 This ought to dramatically decrease print time, yet produce a stunning tile.
|
|
|
Post by jennifer on Mar 21, 2016 19:32:55 GMT
Actually I found out Slic3r and Simplify 3D can do this. I was told that anyways.
|
|